Operation Rules And Maintenance Of Core Cutting Machine

Core cutting machine

Operating procedures

1. Before using the machine, carefully check whether the parts of each part are in good condition, and do not operate with diseases.

2. Plug in the plug and close the external circuit switch, and the motor can run normally.

3. When cutting, due to the manual operation of the core, it must keep a certain distance from the cutterhead. With the different hardness of the rock, the size of the manual force changes, so as to achieve the purpose of safe cutting.

4. The water in the cooling water tank should not be too high, and the lower outer diameter of the cutter head should be 3 ~ 5 mm; When the cutterhead is submerged too deep, because the cutterhead operates at high speed, water is easy to overflow out of the water tank

5. When sanding the end face of the core, adjust the fixture to the plane position of the grinding wheel to sanding. If it is found that the end face of the core is not vertical, the core can be rotated by an angle to continue fine grinding until it reaches the standard.

maintain

After use, remove the dust from the equipment in time to ensure the dryness of the equipment. When it is not used for a long time, it will be put into trial operation after 6 months.