Categories

Contact Us

Hangzhou Hansoar Machinery Co.,Ltd
Add: 119th, Dianxia Road, Guali Town, Xiaoshan District, Hangzhou, China

Ph: +8613738062562

E-mail: info@foilslitter.com

Safety Operation Process And Precautions Of The Slitting Machine

- Apr 14, 2018 -

The slitter is a mechanical device that cuts wide PVC film into multiple narrow materials. When we operate the slitter, we should pay attention to the safety operation process.

First, start the machine

1. open electrical isolation switch (set in front of the electric control cabinet), according to EMERCENCY STOP RESET and READY TO RUN button, the key opens MACHINE to RUN (main platform) to check whether the voltage, current is correct, stable.

2., turn on the hydraulic system power switch (set on the main hydraulic drive rack), check whether the main hydraulic drive system oil level and pressure gauge display is correct and stable.

3., open the pneumatic shut-off valve (set on the intake pipe of the pneumatic control cabinet) to check whether the air pressure is correct (not less than 6.0bar) and stable.

Two. Set control

1., divide the PVC film types, thickness, length and width according to the slicing plan, and set up the slicing menu.

2. file the corresponding PVC film from PDF.

3. set the length and width of the coiling of the corresponding specification film.

4., select the corresponding take-up station, adjust the roll arm and press roller, and install the corresponding specifications of the paper core.

Three, feed, film and film

1. material: according to the requirements of the cutting plan, according to the operating regulations, according to the actual situation, the corresponding parent roll is suspended on the time frame, the inside and outside selection direction of the corona surface is placed on the coiling rack, and the steel core is clamped with the control button, and the steel core support arm and the line car are left.

2. wear film: when the slitting machine is non membranous, it must wear film.  The one end of the original film is attached to the eye of the membrane chain, and the membrane button is started, so that the film is leveled along the roll.

3. contact film: when the cutting machine has film and reel joint, the film table is first started to work position by vacuum film table, the film on the first traction roller of the cutting machine is flattened and the upper vacuum pump suction film is opened, so that the membrane is smoothed on the film table, sticked on the double side tape and cut off the superfluous membrane under the tape, and the reel frame will be placed. The upper membrane flattened and started the lower vacuum pump to make the membrane smooth. Take the paper layer on the tape and smooth the adhesive film. The joint should be neat and unwrinkled, then the vacuum pump is turned off and the film table is opened to the non working position.


Hangzhou Hansoar Machinery Co.,Ltd

Add: No. 43-7, Wenjin Road, Hangzhou Economic 
and Technological Development Zone, Zhejiang, China

Mobile/Whatsapp: +8613738062562

E-mail: info@foilslitter.com


Related Products